ActSafe PME Manual do Utilizador descarregar pdf (Página 24)

24

© Copyright ActSafe Systems AB

SERVICE & MAINTENANCE

Changing the rope grab system

If unsure of any of these steps, contact

ActSafe Systems AB or local distributor.

1. Unscrew the loop inside the textile bag

(2 nuts).

2. Remove the loop, knife and the rope cover

which is mounted on the loop.

3. Unscrew the rope grab and take it o

(5 screws).

4. If necessary change the textile dust pro-

tector (not shown) behind the rope grab.

After cleaning, lubricate the gear ring and

gear wheel with water-proof grease.

5. Replace the rope grab and tighten the

screws to 10 Nm and use Loctite 243.

6. Replace the knife and the loop and

fasten the two M6 nuts with Nordlock

washers at 10 Nm. Make sure the Nord-

lock washers are assembled correctly.

This service must only be performed by

ActSafe or an authorized ActSafe distributor.

DANGER

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Comentários a estes Manuais

Sem comentários